required thickness การใช้

• The difference between the two readings gives the required thickness.
• The aluminum sheet and extruded angles are limited to two required thicknesses, thus simplifying purchases.
• The solution spreads out uniformly, and the substrate is spun until the required thickness is achieved.
• The most serious is said to be on the walls, which are not of the required thickness.
• It had to be built at double the required thickness and then sawed in half, Griffin said.
• Add chicken, kerisik, daun limau purut and daun kunyit and leave to simmer until required thickness is achieved.
• Late-winter warm spells can destroy the texture of the ice, which, while still of the required thickness, will not adequately support weight.
• He hoped the ice would reach the required thickness by about midnight, leaving time for workers to get it ready for practice skating during the day.
• Modern landfills generally require a layer of compacted clay with a minimum required thickness and a maximum allowable hydraulic conductivity, overlaid by a high-density polyethylene geomembrane.
• A stylus of required thickness is set in the trolley and the surface material is removed by applying light pressure as the trolley is moved over the image.
• NASCAR also fined Dale Earnhardt Jr .'s crew chief, Tony Eury Sr ., $ 2, 500 for an unapproved windshield that did not meet the minimum required thickness of one-quarter inch.
• Required thicknesses of each layer of a flexible pavement vary widely depending on the materials used, magnitude, number of repetitions of traffic loads, environmental conditions, and the desired service life of the pavement.
• It is well known that a series inductor represents an approximate lumped circuit model of a short transmission line, and we'll exploit this equivalence to determine the required thickness of the air spacers.
• They used an estimate of the total inventory of less than 500m GEL ( Global Equivalent Layer ), and doubled the required thickness of the cryosphere, which leaves less water available for the hydrosphere than in previous models.
• :First, the thickness : The required thickness of a piece of wire, whether it's an extension cord or Romex installed in your walls, is determined by the current through the wire, and the thermal environment of the wire.
• As regards specifications for the gas-tight armour, the required thickness remained at sixty millimetres, but a requirement was added that appliqu?armour construction techniques not be used, along with a detail requirement that the armour could be cast  with the sections connected by bolts or, preferably, gudgeons  or electrically welded.
• I assume the force is 1 / 2 * density * speed?= 1 / 2 * 1.242 * 100?= 6210 N and the shear strength of cement to be 6000 MPa . I get the required thickness to be 0.26 mm . . which seems wrong . talk ) 06 : 49, 12 November 2013 ( UTC)